Copyright      PREMCHEM 2014. All rights reserved.
Home Home Products Products Contacts Contacts Our Profile Our Profile
A range of Acid Catalysed Laquers with various gloss levels. Chemical Basis: Formulated on an alkyd and nitrocellulose combination and filled with fine particle size extenders. General Qualities: Fast drying laquer, Tough on mar resistant finish, low odour, good build and sanding properties. Physical properties:   Specific Gravity:  0.93 - 0.96 kg/l Flash Point: 23 degree C Non volatile content: 35 - 37% m/m Viscosity: 20 - 22” (catalysed) Ford cup no4 @ 23 degree C Spreading rate: Range Availabilty: Gloss, Matte, Satin, Sheen Recommended Surface: Preparation: Should only be applied over a suitable prepared surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: N/A Overall Coatability: After rubbing it down it can be coated with most types of A/C Products Recommended Thinner: Laquer Thinner Application: Mixing Ratio: 24:1 by volume Application Method: Spray application Viscosity: product supplied ready for use Recommended D.F.T.  Drying Conditions Surface Dry: Air drying at 23 C & 65% relative humidity Flash off time: 5-8 mins @ 23 C Pot Life: 12 hours minimum Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS