Copyright      PREMCHEM 2014. All rights reserved.
Home Home Products Products Contacts Contacts Our Profile Our Profile
Formulated for the protection of vallances, sills, fenders, underbody chassis and load box areas. for the automotive refinish trade. Chemical Basis: Based on a flexible yet durable ater based polymer. General Qualities: A sealer with good stone chip resistance to water, oil and petrol. Easy to apply providing a durable surface with good elasticity. Physical properties:   Density:  Typical 1.3 Flash Point: water based Solid content +/- 50% by vol - +/- 60% by W/T Viscosity: semi viscous, Thixothropic liquid Spreading rate: +/- 3 sq metre / litre fro 150 micron D.F.T Colour Availabiltiy: Black, White, Grey Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: Premchem Auto PRimer, M.S Primer or self-etch primer Overall Coatability: Can be coated with most types of  Premchem topcoats after allwoing stone-chip to dry Recommended Thinner: N/A Application: Mixing Ratio: 1pack product Application Method: spray application Viscosity: product supplied ready for use Recommended D.F.T. vary tremendously depending on texture effect required Drying Conditions Surface Dry: 2-3 hrs @ ambient temperature of 20 degree C also on film thickness apllied Flash off time: N/A Pot Life: N/A Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS