Copyright      PREMCHEM 2014. All rights reserved.
Home Home Products Products Contacts Contacts Our Profile Our Profile
Nitrocellulose based Topcoat, A good quality, fast drying economical refinish coating. Chemical Basis: Alkyd / Nitocellulose binder. General Qualities: Economical, rapid drying and gloss top coats. Physical properties:   Density: +/- 1.01 depending on colour Flash Point: below 21 degree C. Solid content 40% Viscosity: +/- 90 ku’s @ 25 degree C typical Spreading rate: +/- 11 sq metre / litre @ 25 micron dry film thickness Finish: Gloss Colour Availabiltiy: Black, White, Clear and full range of toners. Matte Black also available Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: Premchem Auto Primer, 2K M.S Primer or a Self-Etch primer. Overall Coatability: N/A Recommended Thinner: Grade A Lacquer Thinner / 300D gloss thinner. Application: Application Method: Spray Application Viscosity: 16 to 18 Seconds FC 4 @ 25 degree C. Recommended D.F.T. +/- 15 Microns per coat Drying Conditions Surface Dry: 20-30 minutes Flash off time: 10-20 Minutes Pot Life: N/A One Pack product. Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS