Copyright      PREMCHEM 2014. All rights reserved.
Home Home Products Products Contacts Contacts Our Profile Our Profile
Flexible bodyfiller is a product primarily used for for repair work to damaged vehicle bodies. Chemical Basis: Formulated on a polyester resin base to achieve rapid curing and filled with extenders to give optimum application and filling properties. General Qualities: Rapid curing, easy application, good filling characteristics for all types of body repair work. Physical properties:   Density: Component 1.6 Typical - Catalyst Component 1.0 Typical Flash Point: above 23 degree C. Solid content 80% Viscosity: paste Spreading rate: depending on repair work Colour Availabiltiy: grey and yellwo oxide Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: N/A Overall Coatability: Can be coated with speed sprayfiller, then most types of topcoats. Recommended Thinner: N/A Application: Mixing Ratio: 1% - 2% Catalyst to filler Application Method: putty knife or flexible plastic applicator Viscosity: paste Recommended D.F.T.  Drying Conditions Surface Dry: 5-6 mins Flash off time: N/A Pot Life: 3-4 mins working time after mixing catalyst Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS